GD800 swift comparable acceptor(top insert)

 

 

 

 

 

1. Remove the yellow plastic sample token from the clamp & replace the coin to the clamp.
2. Choose N.O line/ N.C line as a signal line in coordination with the machine specification.
3. Adjust the diameter-rail of lid for preventing bigger invalid coins from inserting.
4. Drive screw off lid-wing if coin thickness is more than2.0mm.
5.Switch to “SW1”:
Fast: 20ms/short pulse signal (Apply to Mario Machine)
Medium: 40ms/medium pulse signal (Apply to different machine)
Slow: 60ms/long pulse signal (Apply to entertainment machine)
Notice: If coin-eating , please adjust the switch.
6. VR turning for sensitivity of coin acceptance: turn clockwise (+)for strict coin selecting : anti-clockwise(-)for slack.
7. If coins couldn`t pass smoothly when SW2 at the precise setting, please switch it to normal setting or adjust VR turning to suitable place.
8. If alarm warns, please clear up the coin channel and then power up.

 

Operation:
1. Firstly remove the yellow plastic token& replace the coin to the clamp.
2. If use RMB 1. please switch (SW3) to RMB Only
3.Choose N.O(Normal Open) or N.C(Normal Close) in coordination with the machine specification. (Normally Mario Machines should be N.C, Gaming Machines be N.O )
4. Switch to “SW2”:
Fast: 25ms/short pulse signal (apply to Mario Machine)
Medium: 50ms/medium pulse signal (apply to different machine)
Slow: 100ms/long pulse signal (apply to entertainment machine)
Notice: If coin-eating , please adjust the switch.
5. VR turning for sensitivity of coin acceptance: turn clockwise (+)for strict coin selecting: anti-clockwise(-)for slack.
6. Lines guide of connector:
1)Gray line
Red line DC+12V
2)White line COIN Signal
3)Black line Ground
4)Gray line